There is no single person legally responsible for edge protection on a UK construction site. Responsibility is shared and layered: the principal contractor holds overall responsibility for coordinating health and safety across the whole site, while each individual contractor is responsible for the areas of work actually under their control. Knowing where that line sits matters, because it’s exactly the kind of gap where a barrier gets removed and never reinstated.
The Principal Contractor’s Site-Wide Responsibility
Under Regulation 13 of the Construction (Design and Management) Regulations 2015, the principal contractor must plan, manage and monitor the construction phase and coordinate health and safety matters across the whole site, so that construction work is carried out without risk, so far as is reasonably practicable. That includes organising cooperation between contractors, coordinating how they apply health and safety requirements consistently, and making sure the construction phase plan is actually followed.
In practical terms, this is the role that owns the overall approach to collective fall protection on a site, deciding where edge protection is needed, specifying it, and coordinating how different trades work around it without compromising it.
Each Contractor’s Responsibility for Their Own Work
Regulation 15 places a parallel duty on every contractor: to plan, manage and monitor the construction work carried out by them, or by workers under their control, so that it’s carried out without risk to health and safety, so far as is reasonably practicable. A contractor must also follow any directions from the principal contractor and the relevant parts of the construction phase plan.
This is where a lot of real-world failures actually happen. A trade working near an edge that has to temporarily move or remove a section of edge protection to get materials through is responsible for making sure that gap doesn’t become a hazard, whether that means reinstating the barrier promptly or putting an equivalent control in place while it’s down.
What If There’s Only One Contractor?
On smaller projects with a single contractor, there’s no principal contractor role to appoint. In that case, Regulation 15 places the equivalent responsibility directly on that one contractor, including drawing up the construction phase plan themselves. The overall site-wide responsibility doesn’t disappear on a smaller project. It simply sits with whoever the sole contractor is.
The Work at Height Regulations Go Further Than “Employer”
The Work at Height Regulations 2005 reinforce this from another angle. Regulation 3 extends the duties that would normally sit with an employer to any person who controls the work of others, to the extent of that control, regardless of whether a formal employment relationship exists. In practice, this closes an obvious gap: responsibility for a safe system of work at height, including edge protection, follows whoever is actually directing or controlling that work on the ground, not simply whoever issues the pay.
What This Means in Practice
- The principal contractor (or sole contractor, on a single-contractor project) owns the overall decision about where edge protection is needed and how it’s coordinated across the site.
- Each contractor is responsible for the work under their own control, including not compromising edge protection while working near it, and reinstating it if it has to come down temporarily.
- Responsibility follows control of the work, not just a formal employment contract, under the Work at Height Regulations.
- None of this removes the individual worker’s own duty to report anything they’re aware of that could endanger themselves or others, a general duty under CDM 2015 that applies regardless of role.
Frequently Asked Questions
Is the principal contractor always responsible for edge protection?
The principal contractor holds overall responsibility for coordinating health and safety, including collective fall protection, across the whole site. Individual contractors are separately responsible for the work under their own control, including not compromising edge protection while they’re working near it.
Who is responsible for edge protection if there’s only one contractor on a project?
That contractor takes on the equivalent responsibility a principal contractor would normally hold, including drawing up the construction phase plan themselves, under Regulation 15 of CDM 2015.
Can a subcontractor be held responsible for removing edge protection?
Yes. Regulation 15 makes each contractor responsible for the work carried out by them or by workers under their control. If a subcontractor removes a barrier to carry out their work, they’re responsible for managing that risk, including reinstating protection promptly.
Rapid-EPS: Supporting the People Who Hold This Responsibility
Rapid-EPS designs and supplies edge protection systems, along with installation guidance and site-based training, to support the principal contractors and contractors who carry this responsibility day to day. To talk through a specific site, contact the team.